Honeywell Granit 1981i - Msi; Msi Check Character

Xenon/Granit User Guide 209
MSI
<Default All MSI Settings>
MSI On/Off
MSI Check Character
Different types of check characters are used with MSI bar codes. You can program
the scanner to read MSI bar codes with Type 10 check characters.
Default = Validate Type 10, but Don’t Transmit.
When Check Character is set to Validate Type 10/11 and Transmit, the scanner
will only read MSI bar codes printed with the specified type check character(s), and
will transmit the character(s) at the end of the scanned data.
When Check Character is set to Validate Type 10/11, but Don’t Transmit, the unit
will only read MSI bar codes printed with the specified type check character(s), but
will not transmit the check character(s) with the scanned data.
Off
On
* Off
* Validate Type 10, but Don’t
Transmit
Validate Type 10 and Transmit