90 Xenon/Granit User Guide
Scan While in Base Cradle
If you want to be able to scan bar codes while the scanner is in the base cradle,
scan the Scan in Cradle On bar code below. If you want to only allow scanning
when the scanner is out of the base cradle, scan Scan in Cradle Off. If you want the
scanner to shut down when in the base cradle, scan Shut Down Scanner in Cradle.
Default = Scan in Cradle On.
Paging
Page Mode
When the scanner is out of the base, the paging button on the base pages the
scanner associated with that base. If you want to disable the paging button, scan
the Page Mode Off bar code, below. When Page Mode is off, the base will no longer
page the scanner when the button is pressed and no scanner is in the base. The red
LED on the base remains lit to indicate that Page Mode is off. (This light will go out
when the button is pressed, then back on when it’s released.) Default = Page Mode
On.
Shut Down Scanner in Cradle
To Next Page
Loading...
