Xenon/Granit User Guide 7
3. If you are connecting a Granit scanner, make sure the cable is pushed tightly
into the scanner. Loosen the locking plate and slide it over the base of the cable
connector to lock the cable in place. Tighten the screw.
Note: The power supply must be ordered separately, if needed.
4. If you are connecting a CCB01-010BTor CCB01-010BT-BF Base, make sure the
cables are secured in the wireways in the bottom of the cordless base and the
base sits flat on a horizontal surface. If you are connecting a CCB02-100BT or
CCB05-100BT Base, see Mount a CCB02-100BT/CCB05-100BT Base on page
9.
5. Plug the serial connector into the serial port on your computer. Tighten the two
screws to secure the connector to the port.
6. Once the scanner or cordless base has been fully connected, power up the
computer.
This interface programs 115,200 baud, 8 data bits, no parity, and 1 stop bit.
CCB01-010BT/CCB01-010BT-BF Base
RS232 Serial Port Connection:
CCB02-100BT/CCB05/100BT Base
RS232 Serial Port Connection:
To Next Page
Loading...
