Parameters accessible with Function Code 03, 06,10h
Fixed Map
Revision 13 HC900 Process Controller Communications User Guide 47
April 2017
Fixed
Start
Address
(hex)
Loop #25 (floating point & bit packed)
Loop #26 (floating point & bit packed)
Loop #27 (floating point & bit packed)
Loop #28 (floating point & bit packed)
Loop #29 (floating point & bit packed)
Loop #30 (floating point & bit packed)
Loop #31 (floating point & bit packed)
Loop #32 (floating point & bit packed)
Set Point Programmer #5 (Additional Values)
Set Point Programmer #6 (Additional Values)
Set Point Programmer #7 (Additional Values)
Set Point Programmer #8 (Additional Values)
Set Point Programmer #5 Segments
Set Point Programmer #6 Segments
Set Point Programmer #7 Segments
Set Point Programmer #8 Segments
Sequencer #4 Step 1 Table (64 steps in sequence)
User defined signal or variable. Read-only if a signal tag. Read/write if a variable.
Note: Additional parameters are available for custom maps only. See Section 6.18.
To Next Page
Loading...
