Configuration | 77
800-22740 - A - 02-2017
Period Define a period during which motion detection is active.
1. Click Set. The Set configuration interface appears.
2. Click Set after a day of the week to set time periods for that
day.
3. Enter a time range (Period) for when the event detection
area is active, then click the check box to activate that
Period.
Note You can configure up to 6 periods within one day.
4. Click Save.
To Copy Time Periods to Other Days
1. Click Set to select a day with configured time periods.
2. Click the boxes besides the days to select the days to
which to copy the periods.
3. Click Save.
Record Channel The system automatically starts recording selected channels
when a motion detection alarm occurs.
Note You need to set the alarm recording period.
Go to Storage
Schedule to configure the current channel
for scheduled recording. See Configuring Local Storage on
page 83.
Delay The system can delay recording for a specified amount of time
after an alarm has ended. Select from 10s to 300s.
Table 3-16 Face Detection Configurations
Configuration Description
To Next Page
Loading...
Need help?
General