EasyManua.ls Logo

Honeywell MPA1 - Managing Configuration Data

Honeywell MPA1
120 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
| 25
Document 800-26311_ A - April 2020
3. Configure the following host settings:
4. Click Save.
Setting the Communication Mode to Web
1. Navigate to Host/Loop Communications:
Dashboard > Panels > Host/Loop Communications, or
Menu > Panel Configuration > Host/Loop Communications.
2. Click to select Web.
Table 2-2 WIN-PAK Host/Loop Communications Mode Settings
Host/Loop Setting Description
Host Connection Type Specifies the type of physical connection between the host and the
Primary panel.
If you are connecting from a host software system such as WIN-PAK,
select one of the following two connection options:
Direct via TCP/IP – Host initiates connection to panel.
Reverse TCP/IP – Panel connects directly to the host system using the
TCP/IP protocol. You must enter the host IP address in the Host IP
Address field. Panel initiates connection to host.
Communication
Type
Specifies the type of communications.
Ack/NAK – Provides a response (either an acknowledgment or a
non-acknowledgment) in a transmission between the host and panel(s).
This is the recommended communications type.
Non Ack/NAK Does not provide a response (either an acknowledgment
or a non-acknowledgment) in a transmission between the host and
panel(s). Normally used in troubleshooting only.
Host IP Address Enter the host system (or WIN-PAK server) IP address here if you selected
Reverse TCP/IP in the Connection Type field on this screen.
Port Number Specifies the port number for the Ethernet port. Port 2101 is Encrypted
(default). Port 3001 is Direct TCIP/IP. Port 5001 is Reverse TCP/IP.
Generate Key Click to create and display a new encryption key.
Note Whenever this box is checked and the page is saved, the new key
must be entered in WIN-PAK.
Disable Encryption Select to disable encrypted communication between MPA1 Primary and
WIN-PAK Host. Disabling encryption creates an insecure system and is
not recommended.
Encryption Key This is the password/key used to encrypt communications between
Primary and WIN-PAK Host. You must enter this password on WIN-PAK
Host.

Table of Contents

Related product manuals