FireWarden 100-2/E — P/N 52778:A 11/04/2005 59
Master Programming Level Programming
Type Monitor
Using the VeriFire Warden Upload/Download utility program, unique user-defined monitor types
can be created and loaded into the FACP for later use. The FACP response to the activation of a
user-defined type is the same as most previous standard types in the list, thus allowing a variety of
user-defined types and responses. To select the type of monitor module being programmed, press
the 2 key while viewing the Edit Monitor Screen #2. This will cause the control panel to display
the following Monitor Type Screens:
Pressing the down arrow key will display additional Monitor Type screens. While viewing one of
the Monitor Type screens, select the type of monitor module being programmed by pressing the
corresponding keypad number key. The display will return to the Edit Monitor Screen #2 which
will show the new type selection.
Table 3.1 on page 60 lists the Monitor Types and their respective functions.
EDIT MONITOR
1=ENABLED
2=TYPE MONITOR
Edit Monitor Screen #2
MONITOR TYPE
1=PULL-STATION
2=USER-DEFINED-1
3=WATERFLOW
Monitor Type Screen #1
To Next Page
Loading...
