SF61 Cordless Scanner User’s Guide 3
The SF61B can be charged using various types of charger (Single Bay Charge
Cradle, Single Bay USB Charger, Quad Charge FlexDock Kit, Single Bay AC Charger
and Vehicle Power Adapter Kit). For more details see Accessories on page 10.
Make sure you fully charge the battery before you start to use the SF61B. Should a
problem arise with the battery, you can replace it (see Replace the Battery of the
SF61B on page 48).
To Charge the Scanner Battery
Place the SF61B in a charger bay or connect it to the vehicle power adapter. The
scanner beeps twice (two-tone beep) and the status light shows the charge status:
• A fixed red light indicates "Scanner Charging"
• A fixed green light indicates "Scanner Fully Charged"
SF61B with the 1-Bay Charger
It takes approximately 3 hours to charge a fully discharged battery.
Note: Charging time is longer in temperatures of 35° C/95° F and higher.
Caution: Improper battery replacement or incompatible device usage may
result in risk of burns, fire, explosion, or other hazard. Dispose of
lithium-ion batteries according to local regulations. Risk of fire and
burns if improperly handled. Do not open, crush, heat above 60°C
(140°F), or incinerate.
12
6
9
3
1
2
7
8
10
11
4
5
To Next Page
Loading...
Need help?
General
