CHAPTER
3
SF61 Cordless Scanner User’s Guide 31
CONFIGURE THE SF61B
CORDLESS SCANNER
Basic Setup with Configuration Barcodes
This section provides configuration barcodes for a basic setup of your scanner.
Many more configuration options are available with EasySet or with your
Honeywell computer, see Configure Your Scanner with EasySet and Configure Your
Scanner from Your Honeywell Computer.
Default values are indicated by “(*)” in this manual and in EasySet.
Reset Your Scanner (Software Reset)
Read the Reset Factory Defaults configuration barcode to reset your scanner
parameter settings to their initial values.
Reset Factory Defaults
You can also perform a software reset of your SF61B using one of the following
methods:
• By sending a Reset Factory Defaults command to the scanner in online setup
with EasySet (see Online Setup with EasySet in the present chapter).
• By forcing a software reset of the scanner (see Force a Software Reset on page
41).
The resulting software reset will reset your scanner parameter settings to their
initial values so you will have to reconfigure any custom settings you have
programmed in your scanner.
Note: Depending on your host configuration (device, Bluetooth version), after a software
reset of your scanner (Reset factory defaults) you may have to re-pair your product
with your host device /application (see the appropriate section in Chapter 2, Connect
the SF61B), and in all cases you will have to re-connect with your host.
To Next Page
Loading...
Need help?
General
