SF61 Cordless Scanner User’s Guide 43
3. Scan the following Barcodes:
Get Firmware Version
Get Sub-system Version
Get Decode Version
The version information is displayed in your host application.
Use EasySet to Display Current Version Information
You can use EasySet to get version information if your SF61B is connected using
an HID connection or a host-initiated (Outgoing) SPP connection.
To Get Version Information by Reading Barcodes
1. Follow the procedure for online setup with EasySet (see Online Setup with
EasySet on page 34).
2. When the scanner is connected to EasySet, open the Configuration modes and
utilities section in the EasySet commands window.
The current firmware, subsystem and decode versions appear in blue next to
the Get Firmware version, Get Sub-system versions and Get Decode version
commands.
Upgrade the SF61B Firmware
You may need to upgrade the SF61B firmware if there is an update that
incorporates changes to a feature or adds functionality to the scanner. When you
upgrade your scanner, the current settings are erased and replaced with the
default settings.
After a firmware upgrade, you will need to re-establish Bluetooth communication
between your SF61B and the other Bluetooth devices and applications in your data
collection system.
Upgrading the SF61B takes about 10 minutes to complete.
Note: Depending on your host configuration (device, Bluetooth version), after a firmware
upgrade of your scanner you may have to re-pair your product with your host device
/application (see the appropriate section in Chapter 2, Connect the SF61B).
To Next Page
Loading...
Need help?
General
