8 SF61 Cordless Scanner User’s Guide
Beeps and Vibrate Alert
Note: The following table shows the default behavior of the beeps and vibrate alert, you can
use EasySet to modify many of these settings if you wish (Operating settings >
Beeps / LEDs).
The SF61B beeps to give you audio feedback and vibrates when performing some
functions. For example, you hear a beep each time you scan a valid barcode.
Using Vibrate Alert
Note: You can use EasySet to modify the default vibrate alert settings if you wish
(Operating settings > Beeps / LEDs > Vibrate alert).
In this Manual and in EasySet, default settings are indicated by “(*)" after the name of
the default setup command.
You can configure the SF61B to vibrate when it successfully decodes a barcode.
This feature can be useful in these situations:
• You are in a noisy environment, such as a busy warehouse, where it can be
difficult to hear the beeps.
• You are working in a quiet environment, such as a library, where you do not want
to make a lot of noise.
Default SF61B Beep and Vibrate Alert Descriptions
Beep Sequence What it Means
Single beep and vibrate alert Good read - the scanner successfully scanned a barcode.
Two fast beeps and vibrate
alert
Power-up.
Two fast beeps The scanner successfully scanned a configuration barcode.
Two beeps, bi-tonal The scanner is docked correctly in a battery charger.
Six very fast beeps and
vibrate alert
Transmission error
or
Configuration barcode was not accepted.
Series of beeps from low to
high
The scanner is connecting to a Bluetooth host.
Series of beeps from high to
low (cannot be deactivated)
The scanner is disconnecting from a Bluetooth host.
Note 1: The scanner does not beep when disconnecting automatically
after a long period of inactivity.
Note 2: The scanner performs a hardware reset (restart) when it is
disconnected from EasySet (two beeps and a vibrate alert by default).
Six-beep melody (cannot be
deactivated)
Scanner confirmation after rescue procedure (see Chapter 4).
To Next Page
Loading...
Need help?
General
