SF61 Cordless Scanner User’s Guide 5
In this Manual and in EasySet, default settings are indicated by “(*)" after the name
of the default setup command.
Turn On the SF61B
To turn the scanner On, press and release the scan button. The SF61B beeps twice
and vibrates at power-up (default behavior).
If your scanner connects or reconnects to a Bluetooth host device / application, it
emits a series of beeps from low to high and the blue Honeywell Ready-to-Work
indicator turns solid blue (default scanner behavior).
Pair with a Bluetooth Host Device
If your SF61B is discoverable (not connecting or not already connected to a
Bluetooth host) you can pair it with a Bluetooth host device and establish a
Bluetooth connection between the two devices (see Connect the SF61B beginning
on page 15).
Note: Being discoverable is the default behavior of the SF61B, but you can use EasySet to
make your product not discoverable if you wish (Interface > Bluetooth >
Discoverable > Not discoverable).
Connect on Power-Up
While the scanner is waiting for a connection, the blue Honeywell Ready-To-Work
LED blinks slowly.
Host-Initiated (Outgoing) SPP Connection
If your scanner is paired with a Bluetooth host device and was connected when it
powered down, you will have to re-establish the connection manually when it
powers up again.
After 5 minutes of inactivity (default behavior, modifiable), it will power down if the
connection is not established.
All Other Connection Types
If your scanner is paired with a Bluetooth host device and was connected when it
powered down, it will automatically try to reconnect at power-up.
After 5 minutes of inactivity (default behavior, modifiable), it will power down if the
connection is not established.
To Next Page
Loading...
Need help?
General
