48 SF61 Cordless Scanner User’s Guide
Replace the Battery of the SF61B
To Change the Battery
1. Loosen the screw holding the battery cover.
2. Remove the battery cover.
3. Disconnect the battery cable and remove the battery.
4. Install the new battery
• Plug in connector
• Place connector side of battery gently against foam padding
• Lower the battery in to place
5. Install the battery cover and tighten the screw (56 N cm/4.956 in-lb).
Note: Do not apply excessive pressure to the battery cover when removing and installing
the screw (applying excessive pressure on the battery cover during removal/
installation may damage your product).
Caution: Integrated circuits on printed circuit boards (PCBs) in this
equipment are sensitive to damage by electrostatic discharge
(ESD). Prevent ESD by always wearing skin contact ground straps
firmly attached to the equipment metal base assembly when
working inside of the equipment housing. Failure to comply may
result in damage to PCB components.
To Next Page
Loading...
Need help?
General
