4 - 14
Object Detection Distance
When the scanner is in the stand and you are using Object Detection
Mode, you can set the distance range for detecting objects. Short sets the
scanner to detect objects approximately 5 inches (12.7cm) away from the
nose. Long sets it to detect objects approximately 10 inches (25.4cm)
away.
Default = Short In-Stand, Long Out-of-Stand.
Character Activation Mode
You may use a character sent from the host to trigger the scanner to begin
scanning. When the activation character is received, the scanner continues
scanning until either the Character Activation Laser Timeout (page 4-15), the
deactivation character is received (see Deactivation Character on page 4-16),
or a bar code is transmitted. Scan the following On bar code to use character
activation, then use Activation Character (following) to select the character you
will send from the host to start scanning.
Default = Off.
Activation Character
This sets the character used to trigger scanning when using Character
Activation Mode. On the ASCII Conversion Chart (Code Page 1252), page
A-4, find the hex value that represents the character you want to use to
Long
In-Stand
* Short
In-Stand
* Long
Out-of-Stand
Short
Out-of-Stand
To Next Page
Loading...
Need help?
General
Weight and Dimensions
