3 - 22
Using the Scanner with Bluetooth Devices
The scanner can be used either with the CCB00-010BT charge base or with
other Bluetooth devices. Those devices include personal computers and lap-
tops.
Scanning the following Non-Base BT Connection bar code allows the scanner
to be used with other Bluetooth devices (e.g., PC/laptop). After you scan the
Non-Base BT Connection bar code, follow the instructions supplied with your
Bluetooth device to locate the scanner and connect to it.
Note: If you go out of range with your scanner, the scanner will not reconnect to
the Bluetooth device when it is back in range.
To relink to the charge base, scan the Base BT Connection bar code.
Changing the Scanner’s Bluetooth PIN Code
Some devices require a PIN code as part of the Bluetooth security fea-
tures. Your scanner’s default PIN is 0000, which you may need to enter the
first time you connect to your non-base Bluetooth device. To change the
PIN, scan the following bar code and then scan the appropriate numeric
bar codes from the Programming Chart inside the back cover of this man-
ual. (The PIN code must be between 1 and 16 characters.) Scan Save to
save your selection.
Default = 0000.
Minimizing Bluetooth/ISM Band Network Activity
The following settings can help you customize the relinking behavior of the
cordless system to obtain the best compromise between convenience and low
interference.
Note: ISM band refers to the 2.4 to 2.48 GHz frequency band used by wireless
networks, cordless phones, and Bluetooth.
Non-Base BT Connection
Base BT Connection
To Next Page
Loading...
Need help?
General
Weight and Dimensions
