Honeywell Voyager 1202G User Manual

3 - 8
Reset Scanner
Scanning this bar code reboots the scanner and causes it to relink with the
base.
Scanning While in Base Cradle
If you want to be able to scan bar codes while the scanner is in the base, scan
the following Scanning in Cradle On bar code. If you want to only allow scan-
ning when the scanner is out of the base, scan Scanning in Cradle Off.
Default = Scanning in Cradle On .
Note: When Scanning in Cradle Off is selected, the scanner will not scan any
bar codes while it is in the base. It will only scan when removed from the
base.
Paging
Paging Mode
By default, the paging button on the base pages the scanner associated
with that base. If you want the paging button on your base to be disabled,
scan the following Paging Mode Off bar code. When Paging Mode is off,
the base will no longer page the scanner when the button is pressed. The
Reset Scanner
Scanning in Cradle Off
* Scanning in Cradle On

Honeywell Voyager 1202G Specifications

General

Type	Handheld bar code reader
Sensor type	Laser
Scanner type	1D
Pitch reading angle	60 - 60 °
Linear (1D) barcodes supported	-
Wireless range	10 m
Bluetooth version	2.1+EDR
Operating frequency	2.4 - 2.5 MHz
Standard interfaces	Bluetooth
Connectivity technology	Wireless
Battery life	12 h
Charging time	4 h
Input voltage	5 V
Battery capacity	1800 mAh
Power source type	Battery
Number of reads per charge	45000
Product color	Black
International Protection (IP) code	IP42
Storage temperature (T-T)	-5 - 35 °C
Operating temperature (T-T)	5 - 40 °C
Operating relative humidity (H-H)	0 - 95 %
Sustainability certificates	RoHS
Harmonized System (HS) code	84716070

Weight and Dimensions

Depth	180 mm
Width	66 mm
Height	92 mm
Weight	180 g
Base weight	185 g
Base dimensions	200 x 67 x 97 mm