3 - 20
Batch Mode Transmit Delay
Sometimes when accumulated scans are sent to the host system, the
transmission of those scans is too fast for the application to process. To
program a transmit delay between accumulated scans, scan one of the fol-
lowing delays.
Default = Off.
Note: In most cases, a short (250 ms (milliseconds)) delay is ideal,
however, longer delays may be programmed. Contact Technical
Support (page 13-2) for additional information.
Scanner Name
You may assign a name to each scanner you are using for identification pur-
poses. The default name is “Voyager.”
Perform the rename operation using either the bar codes on page 3-21, or by
sending the serial command :Voyager:BT_NAM
name
. where
name
is the new
name for the scanner. If you wish to change the names of additional scanners,
link them to the base one at a time and repeat the :Voyager:BT_NAM
name
.
command for each scanner.
* Batch Mode Transmit Delay Off
(No Delay)
Batch Mode Transmit Delay Short
(250 ms)
Batch Mode Transmit Delay Medium
(500 ms)
Batch Mode Transmit Delay Long
(1000 ms)
To Next Page
Loading...
