3 - 12
Override Locked Scanner
If you need to replace a broken or lost scanner that is linked to a base, scan the
following Override Locked Scanner bar code with a new scanner and place
that scanner in the base. The locked link will be overridden, the broken or lost
scanner’s link with the base will be removed, and the new scanner will be linked.
Out-of-Range Alarm
If your scanner is out range of the base, an alarm sounds from the scanner.
The alarm stops when the scanner is moved closer to the base, when the base
connects to another scanner, or when the alarm duration expires.
Note: If you are out of range when you scan a bar code, you will receive an error
tone even if you do not have the alarm set. You receive the error tone
since the data could not be communicated to the base or the host.
Alarm Sound Type
Set the alarm type for the scanner by scanning the following appropriate
bar code. If the alarm is on, the scanner will emit 3 long, high pitched
beeps.
Default = Alarm On.
Alarm Duration
To set the the length of time you want the Out-of-Range alarm to sound,
scan the following bar code and then set the time-out duration (from 0-3000
seconds) by scanning digits on the Programming Chart inside the back
cover, then scanning Save.
Default = 1 sec.
Override Locked Scanner
(Single Scanner)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
