Honeywell Voyager 1202G - Wincor Nixdorf Terminal Default Settings

2 - 11
Note: If you are having unexpected results with this programming code, scan
the Activate Defaults bar code on page 1-9 first, then scan the
programming code above.
Wincor Nixdorf Terminal Default Settings
Scan the following Plug and Play code to program the scanner for a Wincor Nix-
dorf terminal. This bar code sets the baud rate to 9600 bps and the data format
to 8 data bits, no parity, 1 stop bit.
Note: If you are having unexpected results with this programming code, scan
the Activate Defaults bar code on page 1-9 first, then scan the
programming code above.
NCR Bioptic Settings
Wincor Nixdorf Terminal Settings