3 - 19
Transmit Records Automatically
If you are operating in Inventory Batch Mode (see Inventory Batch Mode on
page 3-14), you can transmit all stored data to the host system when the
scanner is placed in the base. If you don’t want the records transmitted
when the scanner is placed in the base, scan the Don’t Transmit Records
Automatically bar code.
Default = Don’t Transmit Records Automatically.
Transmit Records to Host
If you are operating in Inventory Batch Mode (see Inventory Batch Mode on
page 3-14), and your scanner is set to Don’t Transmit Records Automat-
ically, you must scan the following bar code to transmit all stored records to
the host system.
* Don’t Transmit Records
Automatically
Transmit Records Automatically
Transmit Inventory Records
To Next Page
Loading...
