3 - 13
Scanner Power Time-Out Timer
Note: Scanner Power Time-out Timer only applies to cordless systems. It does
not apply to corded scanners.
When there is no activity within a specified time period, the scanner enters low
power mode. Scan the appropriate scanner power time-out bar code to change
the time-out duration (in seconds).
If the scanner is not activated during the timer interval, the scanner goes into
power down mode. Whenever the scanner is activated, the timer is reset. If
Scanning While in Base Cradle (page 3-8) is disabled, the scanner will still go
into power down mode.
Default = 3600 seconds.
Note: When the scanner is in power down mode, press the scanner’s button to
power the unit back up. There will be a set of power up beeps and a delay
of up to a few seconds for the radio to join. The scanner will then be ready
to use.
Batch Mode
Batch mode is used to store bar code data when a scanner is out of range of its
base, or when performing inventory. The data is transmitted to the base once
the scanner is back in range or when the records are manually transmitted.
Timer Off
200 seconds
400 seconds
900 seconds
* 3600 seconds
7200 seconds
To Next Page
Loading...
Need help?
General
Weight and Dimensions
