Honeywell Voyager 1202G - No Read Indicator Configuration

4 - 22
When the output sequence is Off , the bar code data is output to the host as
the scanner decodes it.
Default = Off.
No Read
With No Read turned On, the scanner notifies you if a code cannot be read. If
using an EZConfig-Scanning Tool Scan Data Window (see page 9-2), an “NR”
appears when a code cannot be read. If No Read is turned Off, the “NR” will
not appear.
Default = Off.
If you want a different notation than “NR,” for example, “Error,” or “Bad Code,”
you can edit the output message (see Data Formatting beginning on page 6-1).
The hex code for the No Read symbol is 9C.
Required
On/Not Required
*Off
On
* Off