1 - 3
4. Verify the scanner or base operation by scanning a bar code from the
Sample Symbols in the back of this manual.
The unit defaults to a USB PC Keyboard. Refer to page 2-5 for other USB
terminal settings.
For additional USB programming and technical information, refer to “USB
Application Note,” available at www.honeywellaidc.com.
Connecting with Keyboard Wedge
A scanner or base can be connected between the keyboard and PC as a
“keyboard wedge,” where the scanner provides data output that is similar to
keyboard entries. The following is an example of a keyboard wedge con-
nection:
1. Turn off power and disconnect the keyboard cable from the back of the
terminal/computer.
Connect the appropriate interface cable to the scanner and to the terminal/computer.
only if
power
supply is
included
To Next Page
Loading...
