EasyManuals Logo

Honeywell Voyager 1202G User Manual

Honeywell Voyager 1202G
288 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #139 background imageLoading...
Page #139 background image
7 - 5
Select Require to prevent the scanner from decoding a single “D” Codabar
symbol without its companion. This selection has no effect on Codabar
symbols without Stop/Start D characters.
Concatenation Timeout
When searching for bar codes during concatenation, you may wish to
set a delay used to find the next bar code. Set the length (in millisec-
onds) for this delay by scanning the following bar code, then setting the
timeout (from 1-65535 milliseconds) by scanning digits from the
Programming Chart, then scanning Save.
Default = 750.
Codabar Redundancy
If you are encountering errors when reading Codabar bar codes, you may
want to adjust the redundancy count. Redundancy adjusts the number of
times a bar code is decoded before transmission, which may reduce the
number of errors. Note that the higher the redundancy count, the longer it
will take to decode the bar code. To adjust the redundancy, scan the follow-
ing Codabar Redundancy bar code, then scan a redundancy count
between 0 and 10 on the Programming Chart inside the back cover of this
manual. Then scan the Save bar code.
Default = 0.
On
* Off
Require
Concatenation Timeout
Codabar Redundancy

Table of Contents

Other manuals for Honeywell Voyager 1202G

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honeywell Voyager 1202G and is the answer not in the manual?

Honeywell Voyager 1202G Specifications

General IconGeneral
TypeHandheld bar code reader
Sensor typeLaser
Scanner type1D
Pitch reading angle60 - 60 °
Linear (1D) barcodes supported-
Wireless range10 m
Bluetooth version2.1+EDR
Operating frequency2.4 - 2.5 MHz
Standard interfacesBluetooth
Connectivity technologyWireless
Battery life12 h
Charging time4 h
Input voltage5 V
Battery capacity1800 mAh
Power source typeBattery
Number of reads per charge45000
Product colorBlack
International Protection (IP) codeIP42
Storage temperature (T-T)-5 - 35 °C
Operating temperature (T-T)5 - 40 °C
Operating relative humidity (H-H)0 - 95 %
Sustainability certificatesRoHS
Harmonized System (HS) code84716070
Weight and Dimensions IconWeight and Dimensions
Depth180 mm
Width66 mm
Height92 mm
Weight180 g
Base weight185 g
Base dimensions200 x 67 x 97 mm

Related product manuals