7 - 26
Concatenation Timeout
When searching for bar codes during concatenation, you may wish to set a
delay used to find the next bar code. Set the length (in milliseconds) for
this delay by scanning the bar code below, then setting the timeout (from 1-
65535 milliseconds) by scanning digits from the Programming Chart, then
scanning Save.
Default = 750.
ISBT 128 Predefined Concatenation Sequences
Note: You must enable Code 128 and ISBT 128 to use this feature.
The following bar codes are used to select the pre-defined ISBT 128 Con-
catenation Sequence you wish to use. Once you have selected the concat-
enation sequence, use ISBT 128 Predefined Concatenation Sequences
On/Off to enable this feature.
Default = Donation ID Number (001)
and ABO/RhD Blood Groups (002).
* Donation ID Number (001)
and ABO/RhD Blood Groups (002)
Product Code (003) and
Expiration Date (Form 4)
Product Code (003) and
Expiration Date (Form 3)
Product Code (003) and
Expiration Date (Form 1)
Donation ID Number (001) and
Confidential Unit Exclusion
Status
Donation ID Number (001) and
Donor ID Number (019)
Product Code (003) and
Expiration Date (Form 2)
To Next Page
Loading...
