7 - 67
China Post (Hong Kong 2 of 5) On/Off
China Post (Hong Kong 2 of 5) Redundancy
If you are encountering errors when reading China Post (Hong Kong 2
of 5) bar codes, you may want to adjust the redundancy count. Redun-
dancy adjusts the number of times a bar code is decoded before trans-
mission, which may reduce the number of errors. Note that the higher
the redundancy count, the longer it will take to decode the bar code.
To adjust the redundancy, scan the China Post (Hong Kong 2 of 5)
Redundancy bar code below, then scan a redundancy count between
0 and 10 on the Programming Chart inside the back cover of this man-
ual. Then scan the Save bar code.
Default = 0.
China Post (Hong Kong 2 of 5) Message Length
Scan the bar codes below to change the message length. Refer to
Message Length Description (page 7-2) for additional information.
Minimum and Maximum lengths = 1-80. Minimum Default = 3, Maxi-
mum Default = 80.
China Post (Hong Kong 2 of 5)
Redundancy
Minimum Message Length
Maximum Message Length
To Next Page
Loading...
