Honeywell Voyager 1202G - Page 246

10 - 36
Telepen Default All Telepen
Settings
TELDFT 7-33
*Off TELENA0 7-33
On TELENA1 7-33
Telepen Output *AIM Telepen Output TELOLD0 7-33
Original Telepen
Output
TELOLD1 7-33
Telepen Redundancy Range (0 - 10) *0 TELVOT## 7-34
Telepen Message
Length
Minimum (1 - 80) *3 TELMIN## 7-34
Maximum (1 - 80)
*80
TELMAX## 7-34
UPC-A Default All
UPC-A Settings
UPADFT 7-35
Off UPAENA0 7-36
*On UPAENA1 7-36
UPC-A Number
System
Off UPANSX0 7-35
*On UPANSX1 7-35
UPC-A Check Digit Off UPACKX0 7-35
*On UPACKX1 7-36
UPC-A 2 Digit
Addenda
*Off UPAAD20 7-36
On UPAAD21 7-36
UPC-A 5 Digit
Addenda
*Off UPAAD50 7-36
On UPAAD51 7-36
UPC-A Addenda
Required
*Not Required UPAARQ0 7-36
Required UPAARQ1 7-36
Addenda Timeout Range (0 - 65535)
*100
DLYADD##### 7-37
UPC-A Addenda
Separator
*Off UPAADS0 7-37
On UPAADS1 7-37
UPC-A Redundancy Range (0 - 10) *0 UPAVOT## 7-37
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric
entry
Page