EasyManuals Logo

Honeywell Voyager 1202G User Manual

Honeywell Voyager 1202G
288 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
Product Agency Compliance - Voyager 1200g
USA
FCC Part 15 Subpart B Class B
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a
Class B digital device pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radi-
ate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communica-
tions. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equip-
ment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio or television technician for
help.
If necessary, the user should consult the dealer or an experienced radio/
television technician for additional suggestions. The user may find the fol-
lowing booklet helpful: “Something About Interference.” This is available at
FCC local regional offices. Honeywell is not responsible for any radio or
television interference caused by unauthorized modifications of this equip-
ment or the substitution or attachment of connecting cables and equipment
other than those specified by Honeywell. The correction is the responsibil-
ity of the user.
Use only shielded data cables with this system. This unit has been tested
with cables less than 3 meters. Cables greater than 3 meters may not meet
class B performance.
Caution: Any changes or modifications made to this equipment not
expressly approved by Honeywell may void the FCC authorization to oper-
ate this equipment.
UL Statement
UL listed: UL60950-1, 2nd Edition.

Table of Contents

Other manuals for Honeywell Voyager 1202G

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honeywell Voyager 1202G and is the answer not in the manual?

Honeywell Voyager 1202G Specifications

General IconGeneral
TypeHandheld bar code reader
Sensor typeLaser
Scanner type1D
Pitch reading angle60 - 60 °
Linear (1D) barcodes supported-
Wireless range10 m
Bluetooth version2.1+EDR
Operating frequency2.4 - 2.5 MHz
Standard interfacesBluetooth
Connectivity technologyWireless
Battery life12 h
Charging time4 h
Input voltage5 V
Battery capacity1800 mAh
Power source typeBattery
Number of reads per charge45000
Product colorBlack
International Protection (IP) codeIP42
Storage temperature (T-T)-5 - 35 °C
Operating temperature (T-T)5 - 40 °C
Operating relative humidity (H-H)0 - 95 %
Sustainability certificatesRoHS
Harmonized System (HS) code84716070
Weight and Dimensions IconWeight and Dimensions
Depth180 mm
Width66 mm
Height92 mm
Weight180 g
Base weight185 g
Base dimensions200 x 67 x 97 mm

Related product manuals