Vuquest 3320g User Guide 159
Signature Capture Optimize
If you will be using your scanner to capture signatures frequently, you should opti-
mize it for this purpose. However, the speed of scanning bar codes may be slowed
when this mode is enabled. Default = Off.
Below is an example of a signature capture application. In this example, the aimer
is centered over the signature capture area and the button is pushed. A single
beep is emitted, indicating that the scanner has read a Code 128 bar code and the
data has been transferred to the host. An IMGBOX command may now be sent
from the host to specify the coordinates of the signature capture area below that
code, and indicating that only that area containing the signature should be trans-
ferred as an image to the host.
To see this example, align the aimer with the signature area (not with the bar code),
then push the button.
Send the following IMGBOX command string after the button push:
Example: IMGBOX245w37h55y.
Note: Case is not important in the command string. It is used here only for clarity.
The following image is captured:
To Next Page
Loading...
