Honeywell Vuquest 3330 - Wincor Nixdorf Terminal Default Settings; Wincor Nixdorf Beetle Terminal Default Settings

Vuquest 3320g User Guide 13
Note: If you are having unexpected results with this programming code, scan the Activate
Defaults bar code on page 5 first, then scan the programming code above.
Wincor Nixdorf Terminal Default Settings
Scan the following Plug and Play code to program the scanner for a Wincor Nixdorf
terminal. This bar code sets the baud rate to 9600 bps and the data format to 8
data bits, no parity, 1 stop bit.
Note: If you are having unexpected results with this programming code, scan the Activate
Defaults bar code on page 5 first, then scan the programming code above.
Wincor Nixdorf Beetle™ Terminal Default Settings
Scan the following Plug and Play code to program the scanner for a Wincor Nixdorf
Beetle terminal. The following prefixes are programmed for each symbology:
Note: If you are having unexpected results with this programming code, scan the Activate
Defaults bar code on page 5 first, then scan the programming code above.
NCR Bioptic Settings
Wincor Nixdorf Terminal Settings
Symbology Prefix Symbology Prefix
Aztec Code V Interleaved 2 of 5 I
Codabar N MaxiCode T
Code 93 L MicroPDF417 S
Code 128 K PDF417 Q
Data Matrix R QR Code U
EAN-8 B Straight 2 of 5 IATA H
EAN-13 A UPC-A A0
GS1 DataBar E UPC-E C
GS1-128 P All other bar codes M
Wincor Nixdorf Beetle Settings