52 Vuquest 3320g User Guide
Preferred Symbology Time-out
Once you have enabled Preferred Symbology and entered the high and low priority
symbologies, you must set the time-out period. This is the period of time the scan-
ner will search for a high priority bar code after a low priority bar code has been
encountered. Scan the bar code below, then set the delay (from 1-3,000 millisec-
onds) by scanning digits from the inside back cover, then scanning Save. Default =
500 ms.
Preferred Symbology Default
Scan the bar code below to set all Preferred Symbology entries to their default val-
ues.
Output Sequence Overview
Output Sequence Editor
This programming selection allows you to program the scanner to output data
(when scanning more than one symbol) in whatever order your application
requires, regardless of the order in which the bar codes are scanned. Reading the
Default Sequence symbol programs the scanner to the Universal values, shown
below. These are the defaults. Be certain you want to delete or clear all formats
before you read the Default Sequence symbol.
Note: To make Output Sequence Editor selections, you’ll need to know the code I.D., code
length, and character match(es) your application requires. Use the Alphanumeric
symbols from the Programming Chart, beginning on page 341. You must hold the
trigger while reading each bar code in the sequence.
To Add an Output Sequence
1. Scan the Enter Sequence symbol (see Require Output Sequence,page 55).
2. Code I.D.
On the Symbology Charts on page 327, find the symbology to which you want
to apply the output sequence format. Locate the Hex value for that symbology
and scan the 2 digit hex value from the Programming Chart (inside back cover).
Preferred Symbology Time-out
Preferred Symbology Default
To Next Page
Loading...
