Honeywell Vuquest 3330 - Verifone Ruby Terminal Default Settings; Gilbarco Terminal Default Settings

Vuquest 3320g User Guide 11
Verifone
®
Ruby Terminal Default Settings
Scan the following Plug and Play code to program the scanner for a Verifone Ruby
terminal. This bar code sets the baud rate to 1200 bps and the data format to 8
data bits, Mark parity bit, 1 stop bit. It also adds a line feed (LF) suffix an programs
the following prefixes for each symbology:
Note: If you are having unexpected results with this programming code, scan the Activate
Defaults bar code on page 5 first, then scan the programming code above.
Gilbarco
®
Terminal Default Settings
Scan the following Plug and Play code to program the scanner for a Gilbarco termi-
nal. This bar code sets the baud rate to 2400 bps and the data format to 7 data
bits, even parity, 2 stop bits. It also adds a carriage return (CR) suffix and programs
the following prefixes for each symbology:
Note: If you are having unexpected results with this programming code, scan the Activate
Defaults bar code on page 5 first, then scan the programming code above.
* ReM On
Symbology Prefix
UPC-A A
UPC-E A
EAN-8 FF
EAN-13 F
Verifone Ruby Settings
Symbology Prefix
UPC-A A
UPC-E E0
EAN-8 FF
EAN-13 F
Gilbarco Settings