Vuquest 3320g User Guide 165
UTILITIES
To Add a Test Code I.D. Prefix to All Symbologies
This selection allows you to turn on transmission of a Code I.D. before the decoded
symbology. (See the Symbology Charts, beginning on page 209) for the single
character code that identifies each symbology.) This action first clears all current
prefixes, then programs a Code I.D. prefix for all symbologies. This is a temporary
setting that will be removed when the unit is power cycled.
Show Decoder Revision
Scan the bar code below to output the decoder revision.
Show Scan Driver Revision
Scan the bar code below to output the scan driver revision. The scan driver con-
trols image capture.
Add Code I.D. Prefix to
All Symbologies (Temporary)
Show Scan Driver Revision
To Next Page
Loading...
Need help?
General