Vuquest 3320g User Guide 183
Long (3000ms) DLY2RR3000 47
Extra Long (4000ms) DLY2RR4000 47
Aimer Mode Off SCNAIM0 48
*Interlaced SCNAIM2 48
Centering Window Centering On DECWIN1 50
*Centering Off DECWIN0 50
Left of Centering Window (*40%) DECLFT### 50
Right of Centering Window (*60%) DECRGT### 50
Top of Centering Window (*40%) DECTOP### 50
Bottom of Centering Window (*60%) DECBOT### 50
Preferred Symbology On PRFENA1 51
*Off PRFENA0 51
High Priority Symbology PRFCOD## 51
Low Priority Symbology PRFBLK## 51
Preferred Symbology Timeout
(*500) Range 1-3000
PRFPTO#### 52
Preferred Symbology Default PRFDFT 52
Output Sequence Editor Enter Sequence SEQBLK 55
Default Sequence SEQDFT 55
Partial Sequence Transmit Partial Sequence SEQTTS1 55
*Discard Partial Sequence SEQTTS0 55
Require Output Sequence Required SEQ_EN2 55
On/Not Required SEQ_EN1 56
*Off SEQ_EN0 56
Multiple Symbols On SHOTGN1 56
*Off SHOTGN0 56
No Read On SHWNRD1 56
*Off SHWNRD0 56
Video Reverse Video Reverse Only VIDREV1 57
Video Reverse and Standard Bar Codes VIDREV2 57
*Video Reverse Off VIDREV0 57
Working Orientation *Upright ROTATN0 58
Vertical, Bottom to Top (Rotate CCW 90°) ROTATN1 58
Upside Down ROTATN2 58
Vertical, Top to Bottom (Rotate CW 90°) ROTATN3 58
Prefix/Suffix Selections
Add CR Suffix to All Symbologies VSUFCR 61
Selection
Setting
* Indicates default
Serial Command
# Indicates a
numeric entry
Pag
e
To Next Page
Loading...
