Honeywell Vuquest 3330 User Manual

206 Vuquest 3320g User Guide
•Sani-Cloth
®
HB wipes
•Sani-Cloth
®
Plus wipes
• Super Sani-Cloth
®
wipes
• Isopropyl Alcohol wipes (70%)
•CaviWipes
™
•Virex
®
256
•409
®
Glass and Surface Cleaner
•Windex
®
Blue
•Clorox
®
Bleach – 10%
• Gentle dish soap and water
Inspecting Cords and Connectors
Inspect the interface cable and connector for wear or other signs of damage. A
badly worn cable or damaged connector may interfere with scanner operation.
Contact your distributor for information about cable replacement. Cable replace-
ment instructions are on page 206.
Replacing Cables
The standard interface cable is attached to the scanner with an 15-pin modular
connector. The interface cable is designed to be field replaceable.
• Order replacement cables from Honeywell or from an authorized distributor.
• When ordering a replacement cable, specify the cable part number of the
original interface cable.
Replacing an Interface Cable
1. Turn the power to the host system OFF.
b. Disconnect the scanner’s cable from the
terminal or computer.
c. Rotate the two screws counter clockwise to
loosen the screws.
d. Gently pull the connector.
e. Replace with the new cable.
Insert the connector into the socket on the
3320. Rotate the two screws clockwise to
tighten.

Honeywell Vuquest 3330 Specifications

General

Brand	Honeywell
Model	Vuquest 3330
Category	Scanner
Language	English