Honeywell Vuquest 3330 - Good Read Delay; User-Specified Good Read Delay; Manual Trigger Modes

Vuquest 3320g User Guide 37
to an error. To change the number of error beeps, scan the bar code below and then
scan a digit (1-9) bar code and the Save bar code on the inside the back cover of
this manual. Default = 1.
Good Read Delay
This sets the minimum amount of time before the scanner can read another bar
code. Default = 0 ms (No Delay).
User-Specified Good Read Delay
If you want to set your own length for the good read delay, scan the bar code below,
then set the delay (from 0 - 30,000 milliseconds) by scanning digits from the inside
back cover, then scanning Save.
Manual Trigger Modes
When in manual trigger mode, the scanner scans until a bar code is read, or until
the button is released. Two modes are available, Normal and Enhanced. Normal
mode offers good scan speed and the longest working ranges (depth of field).
Enhanced mode will give you the highest possible scan speed but slightly less
Number of Error Beeps/LED Flashes
* No Delay
Short Delay (500 ms)
Medium Delay (1,000 ms)
Long Delay (1,500 ms)
User-Specified Good Read Delay