Vuquest 3320g User Guide 175
The scanner scans until a bar code has been read, until the deactivate command is
sent, or until the serial time-out has been reached (see Read Time-Out on page
119 for a description, and the serial command on page 181).
Resetting the Custom Defaults
If you want the custom default settings restored to your scanner, scan the Activate
Custom Defaults bar code below. This resets the scanner to the custom default
settings. If there are no custom defaults, it will reset the scanner to the factory
default settings. Any settings that have not been specified through the custom
defaults will be defaulted to the factory default settings.
The charts on the following pages list the factory default settings for each of the
commands (indicated by an asterisk (*) on the programming pages).
To Next Page
Loading...
