HP 10504 - Powering on the Switch

40
Figure 35 Setting terminal emulation in Switch Properties dialog box
Powering on the switch
Before powering on the switch, verify the following items:
• You know where the emergency power-off switch for the equipment room is located.
• The switch has been securely mounted.
• All the cards have been correctly installed.
• The unused slots have been installed with blank filler panels.
• All the network cables, fibers, power cords, and grounding cables have been correctly connected.
• The input power voltage meets the requirement of the switch.
• The console cable is correctly connected.
• The terminal or PC used for configuration has started, and its configuration parameters have been
set.
To power on the switch:
Turn on the power source of the switch to power on the switch.
The following is sample output you can see on the terminal:
System is starting...
Booting Normal Extend BootWare.
The Extend BootWare is self-decompressing...................................
.....Done!