4
120 mm
(4.72 in)
5200 RPM 720 CFM
Mounting accessories
Before installing the switch to the rack, install slide rails to the rack. You can order an HP X421 A-Series
Chassis Universal 4-Post Rack Mounting Kit (JC665A), which is referred to as "the rack mounting kit" in
this document.
An HP X421 A-Series Chassis Universal 4-Post Rack Mounting Kit (JC665A) includes cage nuts, screws,
and a pair of slide rails. The length of the slide rails is in the range of 500 mm (19.69 in) to 800 mm
(31.50 in). A pair of slide rails can bear a maximum weight of 350 kg (771.60 lb). Before you use the
slide rails, make sure the following requirements are satisfied:
• The inside depth of the rack falls into the length range of the slide rail.
• The slide rails can support the total weight of the switch chassis and its accessories.
Transceiver modules
The switch supports transceiver modules. You can order transceiver modules according to the transceiver
modules supported by the LPU interfaces. For more information, see Table 22.
T
he switch supports the following transceiver modules:
• 10-Gigabit XFP modules in Table 28
• 1
0-Gigabit SFP+ modules in Table 29
• 1
0-Gigabit SFP+ cables in Table 30
• Gig
abit SFP modules in Table 31
To Next Page
Loading...
