HP 8168E - Page 103

5
:STATus:QUEStionable:CONDition?
Syntax :STATus:QUEStionable:CONDition?
Description This query reads the contents of the QUEStionable:CONDition
register. Only three bits of the condition register are used:
Bit 7, which is 1 when coherence control has been activated
and the chosen power level is too low (that is, below the
Coherence Control Uncalibrated Power for that wavelength).
Bit 9, which is 1 when the temperature in the laser heat
chamber is out of range (stabilizing).
Bit 10, which is 1 when the output has been switched o to
protect the laser diode.
Example OUTPUT 724;":STAT:QUES:COND?"
ENTER 724;A$
:STATus:QUEStionable:ENABle
Syntax :STATus:QUEStionable:ENABle < wsp >< value >
Description This command sets the bits in the ENABle register that
enable the contents of the EVENt register to aect the Status
Byte (STB). Setting a bit in this register to 1 enables the
corresponding bit in the EVENt register to aect bit 3 of the
Status Byte.
:STATus:QUEStionable:ENABle?
Syntax :STATus:QUEStionable:ENABle?
Description This query returns the current contents of the
QUEStionable:ENABle register.
Example OUTPUT 724;":STAT:QUES:ENAB 1536"
OUTPUT 724;":STAT:QUES:ENAB?"
ENTER 724;A$
Remote Commands 5-33