E
Cleaning Connector Interfaces
Caution
Be careful when using pipe-cleaners, as the core and the bristles of the pipe-cleaner are hard
and can damage the interface.
Do not use pipe-cleaners on optical head adapters
, as the hard core of normal pipe cleaners can
damage the bottom of an adapter.
Preferred
Procedure
1. Clean the interface by pushing and pulling a new, dry pipe-cleaner into the
opening. Rotate the pipe-cleaner slowly as you do this.
2. Then clean the interface by rubbing a new, dry cotton-swab over the
surface using a small circular movement.
3. Blow away any remaining lint with compressed air.
Procedure for
Stubborn Dirt
Use this procedure particularly when there is greasy dirt on the interface:
1. Moisten a new pipe-cleaner with isopropyl alcohol.
2. Clean the interface by pushing and pulling the pipe-cleaner into the
opening. Rotate the pipe-cleaner slowly as you do this.
3. Moisten a new cotton-swab with isopropyl alcohol.
4. Clean the interface by rubbing the cotton-swab over the surface using a
small circular movement.
5. Using a new, dry pipe-cleaner, and a new, dry cotton-swab remove the
alcohol, any dissolved sediment and dust.
6. Blow away any remaining lint with compressed air.
Cleaning Procedures E-7
To Next Page
Loading...
