E
Cleaning Bare Fiber Adapters
Bare ber adapters are dicult to clean. Protect from dust unless they are in use.
Caution
Never use any kind of solvent when cleaning a bare ber adapter as
Solvents can damage the foam inside some adapters
.
They can deposit dissolved dirt in the groove, which can then dirty the surface of an inserted
ber.
Preferred
Procedure
Blow away any dust or dirt with compressed air.
Procedure for
Stubborn Dirt
Use this procedure particularly when there is greasy dirt on the adapter:
Caution
Be careful when using pipe-cleaners, as the core and the bristles of the
pipe-cleaner are hard and can damage the adapter.
1. Clean the adapter by pushing and pulling a new
, dry pipe-cleaner into the
opening. Rotate the pipe-cleaner slowly as you do this.
2. Clean the adapter by rubbing a new, dry cotton-swab over the surface using
a small circular movement.
3. Blow away any remaining lint with compressed air.
Cleaning Bare Fiber Ends
Bare ber ends are often used for splices or, together with other optical components, to create a
parallel beam. The end of a ber can often be scratched. You make a new cleave.To do this:
1. Strip o the cladding.
2. Take a new soft-tissue and moisten it with isopropyl alcohol.
3. Carefully clean the bare ber with this tissue.
4. Make your cleave and immediately insert the ber into your bare ber adapter in order to
protect the surface from dirt.
E-8 Cleaning Procedures
To Next Page
Loading...
