1
Making Big Changes to a Parameter
If you are changing the value of a parameter completely, you can directly type
in the value on the keypad, and press
4
ENTER
5
.
Example
To change the output power from 200
W to 1025
W.
1. Press
4
OUTPUT POWER
5
. The cursor moves to P on the right
hand side of the display.
:1540.000nm
P
: 200
W
2. Type the new value for the output power on the numeric
keypad.
:1540.000nm P:102
5
W
3. Press
4
ENTER
5
to end the editing.
Making a Small Change to a Parameter
For small changes to a parameter use
4
EDIT
5
, or the Modify Knob.
Select the parameter and then:
1. Press
4
EDIT
5
,
4
(
5
.
4
)
5
, or turn the Modify Knob slightly. If you start with
Modify Knob the cursor moves to the digit that was most recently changed.
If no digit was changed before, or if you started with another key, the cursor
moves to the position of the most signicant digit of the parameter.
2. If you want to move the cursor and select another digit to edit, use
4
(
5
and
4
)
5
.
3. Enter the new value for the digit at the cursor on the keypad, or by turning
the Modify Knob. If you have entered the value from the keypad, the cursor
moves to the next digit.
4. Repeat steps 2 and 3 to continue editing the value.
5. When you have nished editing the value, press
4
ENTER
5
. The edited value
becomes the new value of the parameter.
Example
To change the wavelength from 1540.000nm to 1542.500nm.
1-6 Getting Started
To Next Page
Loading...
