1-4 Getting Started
Writer: Cheryl Love Saved by: Cheryl Love Saved date: 08/07/97 3:02 PM
Part Number: 247738-002 File name: Ch01.doc
4. With the label on the battery pack facing up and the battery
contacts facing in, reinsert the battery pack into the battery bay
until it clicks into place.
Reinserting the Battery Pack into the Battery Bay
Setting Up the Computer
1. Place the computer on a flat surface near a grounded electrical
outlet.
2. Plug one end of the power cord into the AC Adapter
1
and the
other end into a grounded electrical outlet
2
. Plug the AC
Adapter into the power connector on the rear panel of the
computer
3
.
NOTE:
If the battery light does not turn on to indicate the
battery pack is charging, remove and reinsert the battery pack.
Allow the battery pack to fully charge (the battery light turns
off) before disconnecting external power or removing the
battery pack. You can use the computer while it charges the
battery pack.
To Next Page
Loading...
