HP Armada 7300 - Inserting the Multibay Weight Saver

6-16 Working with Removable Drives
Writer: Cheryl Love Saved by: Rebecca Wiggins Saved date: 08/12/97 10:13 AM
Part Number: 247738-002 File name: Ch06.doc
Inserting the MultiBay Weight Saver
The MultiBay weight saver included with the computer covers the
MultiBay opening without adding the weight of a drive.
When a MultiBay device is not needed, insert the MultiBay
weight saver to protect the MultiBay from dust and debris and to
lessen the weight of the computer.
Inserting the MultiBay Weight Saver
Remove the MultiBay weight saver from the MultiBay as you
would remove a drive:
1. Tilt the computer up to locate the MultiBay release latch and
the notch underneath the outside edge of the MultiBay.
2. Grasp the edge of the weight saver at the notch.
3. Slide the MultiBay release latch toward the back of the
computer and pull the weight saver out of the MultiBay.