HP Armada 7300 - Page 140

17-22 Troubleshooting
Writer: Cheryl Love Saved by: Cheryl Love Saved date: 08/12/97 10:42 AM
Part Number: 247738-002 File name: Ch17.doc
Solving Screen Problems
Continued
Problem Possible Cause Solution
Screen is blank
(
continued
) .
Screen has
overheated.
If computer is in direct
sunlight, move it and
allow it to cool off.
Screen is blank and
the power/suspend
light is blinking.
System is in Suspend. Press the suspend
button to exit Suspend.
Enter your power-on
password if prompted.
Screen is blank, and
the power/suspend
light and battery light
are both blinking.
System is in Suspend
and has entered a
low-battery condition.
Immediately connect the
computer to an external
power source or replace
the battery pack.
Computer screen is
blank and the
external monitor
displays information.
Display is switched to
the external monitor.
Press F
n+F4
to switch to
the computer display.
External monitor
does not display
information.
External monitor was
connected after the
computer was turned
on.
Press
Fn+F4
to switch to
the external monitor.
The external monitor
signal cable or power
cord is not properly
connected.
Verify the cables are
properly connected.
Display on an
external monitor is
distorted.
Incorrect display
device drivers are
installed or incorrect
resolution is set.
Double-click the Display
icon in Control Panel,
click the Settings tab,
and set the correct
display type and
resolution for the external
monitor.
Continued