Removal and replacement procedures 38
DIMMs
To remove the component:
1. Power down the server (on page 20).
2. Extend or remove the server from the rack ("Extend the server from the rack" on page 19, "Remove
the server from the rack" on page 20).
3. Remove the access panel ("Access panel" on page 22).
NOTE: The server ships with at least two DIMMs installed in DIMM slots 1A and 2A.
4. Remove the DIMM.
CAUTION: Be sure to install DIMMs in the proper configuration. Refer to the Documentation CD.
CAUTION: Use only Compaq branded or HP DIMMs. DIMMs from other sources may adversely affect data
integrity.
IMPORTANT: DIMMs do not seat fully if turned the wrong way.
To replace a DIMM, align the DIMM with the slot and insert the DIMM firmly. When fully seated, the
DIMM slot latches lock into place. The following table lists all seven valid combinations of single-rank and
dual-rank DIMM configurations.
Configuration Bank A Bank B Bank C Notes
1 Single
2 Single Single
3 Single Single Single
4 Dual
Online Spare not supported
5 Dual Single
Online Spare not supported
6 Dual Single Single Online Spare not supported
7 Dual Dual
Online Spare not supported
To Next Page
Loading...
Need help?
General
