HP FlexNetwork 5130 HI series User Manual

43
Field Description
Maximum transmission unit MTU of the interface, which is always 1536 and cannot be configured
Physical: InLoopBack The physical type of the interface is inloopback.
Last 300 seconds input rate: 0
bytes/sec, 0 bits/sec, 0 packets/sec
Average input rate during the last 300 seconds:
• bytes/sec—Average number of bytes received per second.
• bits/sec—Average number of bits received per second.
• packets/sec—Average number of packets received per
second.
Last 300 seconds output rate: 0
bytes/sec, 0 bits/sec, 0 packets/sec
Average output rate over the last 300 seconds:
• bytes/sec—Average number of bytes sent per second.
• bits/sec—Average number of bits sent per second.
• packets/sec—Average number of packets sent per second.
Input: 0 packets, 0 bytes, 0 drops
Total number and size (in bytes) of incoming packets of the interface
and the number of dropped packets.
Output: 0 packets, 0 bytes, 0 drops
Total number and size (in bytes) of outgoing packets of the interface
and the number of dropped packets.
# Display brief information about interface Inloopback 0.
<Sysname> display interface inloopback 0 brief
Brief information on interfaces in route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface Link Protocol Primary IP Description
InLoop0 UP UP(s) --
# Display brief information about interface Inloopback 0, including the complete description of the
inloopback interface.
<Sysname> display interface inloopback 0 brief description
Brief information on interfaces in route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface Link Protocol Primary IP Description
InLoop0 UP UP(s) --
Table 10 Command output
Field Description
Brief information on interfaces in
route mode
Brief information about the inloopback interface.
Link: ADM - administratively down;
Stby - standby
Explains the
Link
field values:
• ADM—The interface has been shut down by the network
administrator. To recover its physical layer state, run the undo
shutdown command.
• Stby—The interface is a standby interface.
Protocol: (s) - spoofing
Explains the
Protocol
field value.
(s)
—Represents spoofing. If the data link layer protocol of an interface
is up, but the link is an on-demand link or is not present, the
Protocol
field displays
UP(s)
. This attribute is typical of interface Null 0,
Inloopback 0, and loopback interfaces.
Interface Interface name.

HP FlexNetwork 5130 HI series Specifications

General

Brand	HP
Model	FlexNetwork 5130 HI series
Category	Switch
Language	English