45
LoopBack0
Current state: UP
Line protocol state: UP (spoofing)
Description: LoopBack0 Interface
Bandwidth: 0kbps
Maximum transmission unit: 1536
Internet protocol processing: Disabled
Physical: Loopback
Last clearing of counters: Never
Last 300 seconds input rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Last 300 seconds output rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Input: 0 packets, 0 bytes, 0 drops
Output: 0 packets, 0 bytes, 0 drops
Table 11 Command output
Field Description
Current state
Physical layer state of the loopback interface:
• UP—The loopback interface can receive and transmit packets.
• Administratively DOWN—The interface was manually shut
down by using the shutdown command.
Line protocol state
Data link layer protocol state of the interface.
UP (spoofing)
means
that the data link layer protocol state of the interface is up, but the link
is an on-demand link or is not present.
Description Description string of the interface.
Bandwidth Expected bandwidth of the interface.
Maximum transmission unit MTU of the interface.
Internet protocol processing:
Disabled
Indicates that the interface cannot process Layer 3 packets
(displayed when the interface is not configured with an IP address).
Internet address is 1.1.1.1/32
Primary
Primary IP address of the interface (displayed when the interface is
configured with a primary IP address).
Physical: Loopback The physical type of the interface is loopback.
Last clearing of counters
Time when statistics on the logical interface were last cleared by
using the
reset counters interface
command.
If the statistics of the interface have never been cleared by using the
reset counters interface
command since the device started, this
field displays
Never
.
Last 300 seconds input rate: 0
bytes/sec, 0 bits/sec, 0 packets/sec
Average input rate during the last 300 seconds:
• bytes/sec—Average number of bytes received per second.
• bits/sec—Average number of bits received per second.
• packets/sec—Average number of packets received per
second.
Last 300 seconds output rate: 0
bytes/sec, 0 bits/sec, 0 packets/sec
Average output rate over the last 300 seconds:
• bytes/sec—Average number of bytes sent per second.
• bits/sec—Average number of bits sent per second.
• packets/sec—Average number of packets sent per second.
Input: 0 packets, 0 bytes, 0 drops
Total number and size (in bytes) of incoming packets of the interface
and the number of dropped packets.
Output: 0 packets, 0 bytes, 0 drops
Total number and size (in bytes) of outgoing packets of the interface
To Next Page
Loading...
Need help?
General