Removing and replacing an expansion board
Prerequisites
T-10 Torx screwdriver
Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
• Extend the server from the rack.
• Remove the server from the rack.
4. Remove the access panel.
5. Disconnect any internal cables that are connected to the expansion board.
6. Remove the riser cage.
7. Remove the expansion board:
• Primary riser cage
Removal and replacement procedures 55
To Next Page
Loading...
